2PCS 0.96" OLED Module I2C IIC Serial 12864 128X64 OLED Display Module with SSD1306 Driver for Arduino Raspberry Pi (Yellow & Blue OLED)

• This I2C OLED display module is 0.96 inch diagonal,Resolution: 128 x 64, View angle: > 160°, Support voltage: 3.3V-5V DC, Power consumption: 0.04W during normal operation, full screen lit 0.08W.
• With high resolution of 128 x 64 pixels, no need backlight, self-illumination, pixels stand outvery well even in a brighter circumstances like full sunlight.
• Embedded Driver IC: SSD1306. Communication: I2C/IIC Interface, only need two I / O ports
• With four square holes, our I2C OLED display module can be installed easily, convenient to use and simple you working.
• It can be widely use with Arduino, Raspberry Pi, 51 series, MSP430 series, STM32/2, CSR IC, etc.

This OLED display module is small, only 0.96” diagonal, it is made of 128x64 individual yellow and blue OLED pixels, each one is turn on or off by the controller chip.

It works without backlight, that is, in a dark environment OLED display is higher compared to that of LCD display you will like the miniature for its crispness.

The Driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.

That is, except the VCC and GND, 2 wires would be needed when using 4-wires I2C mode.

There is also a simple switch-cap charge pump that turns 5v into a low voltage drive for the OLEDs, making this module the easiest ways to get an OLED into your project.

Applications:

MP3, MP4, watch

Head-mounted displays

Meters and other intelligent instruments

Design any pretty patterns for your beloved electronic devices!

Package included:

2x  0.96 Inch I2C OLED Display Module